[T3] Mystery Miss
Jim Adney
jadney at VWType3.org
Sat May 7 14:31:58 PDT 2016
On 7 May 2016 at 13:54, Phil Hof wrote:
> One electrical FI gremlin I once had, and is easy to miss (no pun
> intended) was inside those clear connectors (T1 and T2) that you push
> a female tab connector into and slide onto the male spade. One
> example is wire 19 (pump signal) on the engine bay; another is the
> head temp sensor connector. On more than one occasion, I´ve seen them
> pushed into the plastic housing, but instead of being slid OVER the
> male tab, they were slid NEXT TO the tab. It looked fine on the
> outside if the plastic was yellowed or cloudy, and it would make
> contact, but as temperature and vibration did their thing, it could
> lose contact.
Yeah, I've seen that, too. In fact, the first time I saw this it was
done by a dealer mechanic, so it's not just a novice thing. It's easy
to do wrong if you're in a hurry, but also easy to do right if you're
willing to take the extra time to do the job well.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list