[T3] Nose too high.

Jim Adney jadney at vwtype3.org
Thu Jun 20 06:34:30 PDT 2019

On 20 Jun 2019 at 7:27, John Jaranson wrote:

> Checking the blueprint I have for the rear torsion bar housing plate, I get a
> measurement of 7.7 to go along with the 8.3 measurement to the flange at
> the center of the front beam.

I'm not sure if the end plates I suggested measuring from are the 
same for IRS and Swing Axle subframes. They might also be different 
for the AT subframe, which I THINK was different in '69.

Which model is your drawing for, John?

Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA

More information about the type3-vwtype3.org mailing list