[T3] 73 type 3 runner hose and intake gasket replacement?

[William Jahn]

I found one just like my old torque wrench link below.
https://www.ebay.com/itm/Craftsman-944466-Digitork-3-8-Drive-Torque-Wrench-w-Case-Free-Shipping/233221579810?hash=item364d16e422:g:b3wAAOSwcqtc03A-
Maybe some day I'l get a new well made old fashioned beam style if they
still exist.

On Fri, May 10, 2019 at 6:48 PM William Jahn <willjahn975 at gmail.com> wrote:

> I may just make one out of aluminum I have it's .039" thick .
>
> I only have one torque wrench an old sears digitork and wondered how
> accurate it is , Bought it new forget when decades ago. 3/8" drive 5 to 75
> foot pounds and also newton meters . I weighed a container for 14 pounds
> which is the torque for the runner to head nuts and 12" was center of the
> handle and it was 1/2 lb low if I set it at 14.5 foot pounds it clicks if I
> go to 15 it does not. I just hung the water filled jug by a wire drive in
> vice and let the weight on real slow.
>
> Here one that looks like it. Mine is a bit older and has a built in thumb
> wheel near the square drive and a quick socket release button and half the
> shank toward the head is more flat.
>
> https://www.machinesused.com/lots/(2)-Craftsman-Digitork-Torque-Wrenches-19161#&gid=1&pid=2
>
> I had a old 3/8" and 1/2" beam style that I trusted and a snap on 1/2"
> click which vanished with my tool box. I thought I might need a new cheapo
> beam type they sell on amazon for $35 and change. I always read clicker
> type were off the most in the low end 5 ft lb is the lowest mine goes 75
> the highest making 14 foot lb's the low end.
>
> On Wed, May 8, 2019 at 11:17 AM Jim Adney <jadney at vwtype3.org> wrote:
>
>> On 8 May 2019 at 10:15, William Jahn wrote:
>>
>> > My Air temp sensor fits in the left side of the IAD not in the top of
>> the
>> > case it's a 73 .
>>
>> Sorry, you described the right part, but I thought you were asking about
>> the
>> AAR. My mistake.
>>
>> The Temp Sensor gasket is just a thin copper washer.
>>
>> --
>> *******************************
>> Jim Adney, jadney at vwtype3.org
>> Madison, Wisconsin, USA
>> *******************************
>>
>> _______________________________________________
>> VWType3.Org mailing list - type3 at vwtype3.org
>> To unsubscribe or change subscription options, visit:
>> http://lists.vwtype3.org/listinfo.cgi/type3-vwtype3.org
>> If you need more help, contact: gregm at vwtype3.org
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.vwtype3.org/pipermail/type3-vwtype3.org/attachments/20190510/3cac0e9a/attachment.html>