[T3] Flame Thrower Distributor
Jim Adney
jadney at vwtype3.org
Thu Jun 11 07:08:21 PDT 2020
On 10 Jun 2020 at 20:41, charles tupper wrote:
> On an initial install of a Flamethrower distributor in a 67 T3 engine.
> Installed at TDC, on Cyl 1, wires are correctly installed to a Bosch
> Distributor. Is there a way to static time prior to an attempt too start?
> (As you'd do to a set of points with the test light hooked to term 1 on
> the coil and grounded to the case, then rotating the distributor until the
> light goes off, then slight backup to light on). I called
> Pertronics...they said no, but maybe. What would you all suggest?
A couple of options:
Get a helper to turn the key while you rotate the distributor and watch your
timing light.
Get a remote starter switch, so you don't need a helper to do this yourself.
Try the distributor in a few positions until you can get the engine to start,
then set it accurately.
--
*******************************
Jim Adney, jadney at vwtype3.org
Madison, Wisconsin, USA
*******************************
More information about the type3-vwtype3.org
mailing list